A water-based paint that gives a matte effect
An Emulsion (water based) matte paint for interior use consisting of an acrylic copolymer and concentrated chemicals to gain durability and resistance to weather. Used for walls, ceilings, panels, gypsum and concrete surfaces.
1. Used for interior decoration and coatings
2. Used for residential and commercial buildings
3. Used for wall surfaces, ceilings
1 Liquid Component
1. Remove the old paint (if any) completely out of the surface, and to make sure that the surface completely clean and free of dirt, dust, oils and grease.
2. Mix the paint well with a mechanical mixer for 3 minutes until the mixture is homogeneous
3. Apply the Poly Paint with a paint roll.
4. After the first coat has dried up, a second coat of Poly Paint in the opposite direction is recommended.
5. Leave the paint to dry for two hours.
Density: 1.5 at a temperature ° 25 m.
Viscosity: 105 Unit Corps at a temperature ° 25 m.
Solid content: 40% by volume.
Water resistance: Passing 7 days
Alkali resistance: Passing 7 days solution concentration %1.5.
Adhesion strength: Pass
Dryness time: Surface dry 30 minutes. Two hours to complete dryness.
Time interval between two layers coating: Minimum 4 hours.
Diluted: Water
Dilution ratio: 10-15% (by volume, when using a roller and brush.) And it depends on the weather conditions when in use.
This original sealed container has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 25°C.
American National Standards Institute: ASTM D-1308American National Standards Institute:: ASTM D-3359American National Standards Institute: : ASTM D-14American National Standards Institute: : ASTM D-562American National Standards Institute: ASTM 5201American National Standards Institute: ASTM D-870