POLYWED PLUS

POLYWED PLUS ADHESIVE is ageneral purpose tile adhesive that can be applied in high thicknesses for irregular surfaces.

APPLICATION

  • -For permanent fixing of all types of ceramic tiles.
  • Can be used internally and externally.
  • Suitable for bathrooms and kitchens and wet areas.
  • Nonslip,can be used for walls and floors.

ADVANTAGES

  • Extended open/wet time.
  • Water resistance, will not be affected in wet conditions.
  • Ready for use, just requires the addition of water.
  • Nonslip.
  • High bond strength.
  • Suitable for internal and external application.

STANDARDS

  • Complies with BS5980:1980 Class AA,Type1 and ANSIA.118.1
  • Complies with BS EN12004:2001,Type C1 for tensile adhesion strength.
Adjustability ≥ 20 min
Pot life ≥ 8 hours
Open time:

3mm thickness @ 25˚C

≥0.5 N/mm2 after

not less than 20 min.

Tensile adhesion strength after heat immersion:  

≥0.5 N/mm2

Tensile adhesion strength after water immersion:  

≥0.5 N/mm2

Tensile adhesion strength :

(EN 1348:1999)

 

≥0.5 N/mm2

  •  Substrate preparation

All surfaces must be clean and free from oil, grease or loose materials.Substrate should be  dimensionally  stable. Allow time for shrinkage and structural strain movements.

  • Priming

Can  beapplied  directly  on     concrete, cement plaster, screed and cement or line mortar.

  • Mixing

5.0 liters (for each 20 kg bags)of clean water should be added to a clean container. Spread to a uniform thickness of up to 5 mm.Place tiles firmly over the applied area.Do not apply large areas of adhesives that can not be covered with in the open wet time of the adhesive.

  • Joints

Tiles should not be placed over expansion or contraction joints. Stop tiles on joint edges and fill joints with flexible sealant.

CLEANING

All tools should be cleaned immediately after finishing with water.Hardened materials should be cleaned mechanically.

PACKAGING

available in 20 kg bags.