Adhesive anchor system has been specially formulated as a high performance, three epoxy component adhesive anchor system for threaded rods and reinforcing bars in uncracked concrete to suit transport applications.


  • Fast curing
  • Standard guns can be used
  • Can be used at low temperatures
  • High load capacity
  • Non-sag, even overhead
  • Low wastage


Sandy Beige

Density @25oC,kg/ltr


Pot lifemin@25oC


Adhesion to concrete (concretefailure)N/mm2


Tensile Strength N/mm2@7days


Flexural Strength N/mm2@7days


Compressive strength, N/mm@7days


Slant Shear strength, N/mm@7days


  • As a fast curing anchoring adhesive for all grades of: Rebars / reinforcing steel
  • Threaded rods
  • Bolts and special fastening systems Concrete
  • Hollow and solid masonry

Drilling of hole with an electric drill to the diameter and depth required. Drill hole diameter must be in accordance with anchor size.

The drill hole must be cleaned with a blow pump or by compressed air, starting from the bottom of the hole.

The drill hole must be thoroughly cleaned with the special steel brush.

The drill hole must be cleaned with a blow pump or by compressed air, starting from the bottom of the hole.

Mixing Part A + part B + part C Inject the adhesive into the hole.

Insert the anchor with a rotary motion into the filled drill hole. Some adhesive must come out of the hole.

During the resin hardening time the anchor must not be moved or loaded

Anchoring parameters

Hole diameter is all the time related to the embedded steel rebar diameter.

The following table shows that relation which shows obviously the bigger the rebar diameter, the bigger the excess of the hole diameter, and that to give more tolerance for steel notches to be inserted easily.

Rebar diameter (mm)

Hole diameter (mm)

from 6 – 16

Rebar diameter + 4

from 18 – 32

Rebar diameter + 6

over 32

Rebar diameter + 8

Hole depth depends on more than one factor: Concrete compressive strength

Steel rebar grade (tensile strength) Ultimate design axial load Concrete section depth

Steel rebar diameter

Each factor of the mentioned above is affecting the hole depth in different way. The concrete compressive strength is reversely affecting the hole depth i.e. the higher the compressive strength, the less the required hole depth for the same ultimate axial load, etc.

For critical structural usage of POLYWED ANCHOR, we recommend going through pull off test to settle the right anchoring depth.


1Kg and 5Kg