POLYWED EPOXY CLEAR
is clear, two part, solvent free epoxy, high flowable self leveling system specially formulated to be used in decorative artworks. It is abrasion and chemical resistant.
Some special fillers or colored grains could be added to POLYWED EPOXY CLEAR acting as a third component to form variable decorative flowable slurries
POLYWED EPOXY CLEAR is ideal to be used in:
- Sparkling floors of airports, hotels, conference and meeting halls, clubs, showrooms, hospitals, restaurants, museums, luxurious entrances, cinemas, theatres and other recreation
- Over other colored epoxy to give the deep and reflective feelings
- For individual artworks over floors such as logos, instructions and
- Chemical industries
- Good abrasion & slip resistant
- Could be applied for a wide range of thicknesses.
- Reflective smooth
- Hygienic, anti bacterial & fungus
- Long Pot life, Suitable for hot
Shelf life & Storage
12 months storage life if stored in its original unopened containers under dry and shaded place in a temperature from 5oC to 35oC.
The fully cured POLYWED EPOXY CLEAR is resistant to a wide range of chemicals including the common acids, alkalis and solvents, such as Sulfuric Acid, Hydrochloric Acid, Ammonium Hydroxide, Xylene, and White Spirit, as well as Diesel, Gasoline, Engine oils, and detergents.
|Solids Content, %||70|
|Full dry (ASTM D2471) hrs @ 25oC||10|
|Full Cure (ASTM D1640) time days @ 25oC||7|
|Shore D Hardness (ASTM D 2240)||D4541) N/mm2|
|Flexural Strength N/mm2||54±1|
|Abrasion Resistance (ASTM D 4060)||60 mg/1000 cycles (C10 wheels)|
1.02 kg/m2@1000 mic thick
POLYWED EPOXY CLEAR is applied on sound, clean, and dry substrates in order to achieve maximum adhesion oil and grease could be removed, sand blasting or by steam cleaning.
Stir the base only separately. The entire contents of the smaller can (hardener) could be poured into the base container and the materials should be mixed for at least one minute by mechanical mixer using a slow or medium speed mixing drill.
Pour the mixed material onto the dry primed surface or the existing epoxy floor coating and spread to the required thickness using a notched steel trowel. After laying the material it should be rolled immediately with a spiked nylon roller to let the entrained air out.
Don’t apply POLYWED EPOXY CLEAR if:
The temperature of the surface is below 5 OC or over 40OC.
Clean all tools and application equipment
immediately after use.
Hardened and/or cured material can only be removed mechanically.
15 and 5 Kg set.
POLYWED provides on-site assistance, as well as consulting services on projects when requested. Technical data sheets on other POLYWED products and guidance on their use are available on request
Health and Safety
All safety stuff should be worn during application like safety goggles and rubber gloves, to avoid any harmful accidents.
If POLYWED EPOXY CLEAR is splashed accidentally
to the skin, it must be washed off with water and soap at once.
If it was splashed to the eyes or nose, they must be rinsed with plenty amount of clean warm water and seek medical attention immediately
FOR MORE INFORMATION, PLEASE CON- TACT PHONENO.00966 2 6204224