Epoxy material used for restoration and pasting of two components soft rubble and materials fast processing is ideal for use in repair work and fill in the blanks, a strong cohesion but easy to operate using a knife and when dry give high mechanical properties and resists oil, grease, oil, salt and a lot of acid and alkali nor cracks occur after drought and bear degrees temperatures below freezing up to 60 ° C and resistant to mechanical shock resistance and greater mechanical resistance of concrete.
install brick to concrete.
restoration and processing nesting in vertical, horizontal and overhead concrete.
fill in the blanks.
install Ball bearing in metal bridges and beams in concrete bridges.
install screws inside the walls.
install ceramic tiles.
restoration of the columns at the site.
install roof vents to inject cracks.
high adhesion strength
resistant to shocks
resistant to chemicals
gives a surface smooth and easy to use
does not need to pass by land or material link
The mixture density of 1758 kg / cubic meter at a temperature of 25 ° C
Ignition point does not apply
Bonding strength is greater than the strength of concrete thread
Operating period of 1 hour + 45 minutes at 25 ° C
45 min at 40 ° C
Tim for final set 7 hours at 25 ° C
Two hours at 40 ° C
Full cure 5 days at 25 ° C
3 days at 40 ° C
Its chemical resistance to most of the sewage and water systems and sea water and dilute alkali and concentrated and dilute acids, mineral and vegetable oils, grease, ammonia and formaldehyde.
Instructions for Use
Must first remove all oil, grease and dirt before using material.
The complete package mixing using a knife paste preferably mixed mixer to work homogeneity required
Sakina paste is used to obtain the desired thickness and is put a small amount of solvent to increase the usability of the operation and when filling deep voids are advised to be done on several layers.
12 months when you follow the storage conditions.
FOR MORE INFORMATION, PLEASE CON- TACT PHONENO.00966 2 6204224