Two Component Epoxy Primer for Steel.
POLYWED EPOXY STEEL PRIMER is a two component , epoxy based primer , designed to provide active anti-corrosion coating for steel reinforcement.
- Provide a protective coating from corrosion for steel by active electro-chemical means .
- Easy application.
- Cost effective
- Excellent resistance to salt and chloride.
|Gray and White||Color|
|1.85± 0.01 @ 25C||Specific gravity|
|30-60 min @20 C
15-40 min @ 35 C
|50 Micron / Coat||DFT|
|165 Micron / coat||WFT|
INSTRUCTIONS FOR USE:
The steel surface must be cleaned from any corrosion deposits and loose scale . it is recommended to use grit blasting for surface preparation . Steel brush can be used for steel cleaning. In all cases the steel should be clean and bright after cleaning.
Mix contents A & B thoroughly before use.
Use a small brush to apply Epoxy Steel Primer on the prepared surfaces to achieve a uniform and full coverage . Particular attention should be given to reinforcement steel back face. If an unbrocken coating was not achieved by using one coat , a second coat should be applied within the over coat time between 30 -60 minutes .
Application should be carried out as soon as possible after finishing the surface preparation and in all cases not exceed 4 hours.
Tools and equipment can be cleaned with solvent . Dried POLYWED EPOXY STEEL PRIMER may be removed mechanically
Available in 5 Kg and 15 Kg Cans.
Store in dry area away from direct sunlight .
POLYWED EPOXY STEEL PRIMER has shelf life of 12 months if stored in proper conditions and un-opened containers.
POLYWED EPOXY STEEL PRIMER shouldn’t come in contact with skin and eyes . In case of accidental splashes to the eyes , rinse thoroughly with clean water and seek medical advice .
Suitable protective gloves and goggles must be worn . Ensure adequate ventilation and avoid inhalation of vapor.
FOR MORE INFORMATION, PLEASE CON- TACT PHONENO.00966 2 6204224