TILE ADHESIVE FOR INTERNAL AND EXTERNAL USE.
TILE ADHESIVE POLYWED SUPER FRANCE is a general purpose tile adhesive that can be applied in high thicknesses for irregular surfaces.
For permanent ﬁxing of all types of ceramictiles.
Can be used internally and externally.
Non slip, can be used for walls and ﬂoors.
Ready for use, just requires the addition of water. Non slip.
good bond strength.
Suitable for internal and external application.
|Open time:3mm thickness @ 25˚C||6 -10 min|
|Comp. Strength||> 5 KN|
|Min. application Temperature:||60 C|
|Tensile adhesion strength :(EN 1348:1999)||>0. 25|
METHOD OF USE:
All surfaces must be clean and free from oil, grease or loose materials.
Substrate should be dimensionally stable. Allow time for shrinkage and structural strain movements.
can be applied directly on concrete, cement plaster, screed and cement or line mortar.
Prime gypsum boards with POLYBOND SBR
diluted with water at a ratio of 1:2 by volume.
Spread to a uniform thickness of up to 10mm.
Place tiles ﬁrmly over the applied area.
Do not apply large areas of adhesives that cannot be covered within the open wet time of the adhesive.
Tiles should not be placed over expansion or contraction joints. Stop tiles on joint edges and ﬁll joints with ﬂexible sealant.
Approximately 2.1m2/20kg bag at 5mm thickness.
All tools should be cleaned immediately after ﬁnishing with water. Hardened materials should be cleaned mechanically.
is available in 20 kg bags.
shelf life is 12 months if stored at temperature between
20C and 50˚C. If these conditions are exceeded, POLYWED technical department should be contacted for advice.
– Health and Safety:
contains Portland cement and sand TILE ADHESIVE SUPER GP770 may cause irritation to skin or eyes. In case of accidental contact with says, immediately ﬂush with plenty of water for at least 10 minutes and seek medical advice if necessary.
is non ﬂammable.
FOR MORE INFORMATION, PLEASE CON- TACT PHONENO.00966 2 6204224