TILE ADHESIVE FOR INTERNAL AND EXTERNAL USE
POLYWED NO.1 is an underwater tile adhesive, suitable for bonding all types of ceramic tiles on ﬂoor and walls of pools.
For permanent ﬁxing of all types of ceramic tiles used for pools.
Can be permanently submerged.
Suitable for Ceramic tile , Porcelain tile , Terracotta , Kliker , Marble , natural stone and Ceramic mosaic.
Extended open / wet time.
Water resistant, will not be affected in
Ready for use, just requires the addition of water. Non sag.
Very high bond strength.
Suitable for pools and water retaining structures.
BS 5980 Part 10 : 1980 ANSI A.118.1
ANSI A.118.4 (mixed with POLYTILE 25).
|Adjustability||≥ 30 min|
|Pot life||≥ 6 hours|
3mm thickness @ 25˚C
|≥0.5 N/mm2 after not less than 30 min.|
|Tensile adhesion strength
after heat immersion:
|Tensile adhesion strength after water immersion:||≥1 N/mm2|
|Tensile adhesion strength :
METHOD OF USE:
– Surface Preparation:
All surfaces must be clean and free from oil, grease or loose materials.
Substrate should be dimensionally stable. Allow time for shrinkage and structural strain movements.
To ensure proper mixing, a mechanically powered mixer or drill ﬁtted with suitable paddle should be used.
5.0 liters (for each 20 kg bags) of clean water should be added to a clean container. The powder is then added slowly to the water while mixing continuously with low speed mixer/drill (400-600rpm). Mixing should be continued for 3 minutes until a uniform consistency is obtained.
Spread to a uniform thickness of 2 to 3mm. Place tiles ﬁrmly over the applied area. Comb horizontally.
Do not apply large areas of adhesive that cannot be covered within the open wet time of the adhesive.
Tiles should not be placed over expansion or contraction joints. Stop tiles on joint edges and ﬁll joints with ﬂexible sealant.
Approximately 5.5m2 5mm thickness and 6.5m2 3mm thickness /20Kg Bag .
is available in 20kg bags.
shelf life is 12 months if stored at temperatures between 2˚C and 50˚C.
If these conditions are exceeded in any respect, technical department should be contacted for advice.
Health and Safety:
As contains Portland cement, may cause irritation to skin or eyes. In case of accidental contact with eyes, immediately ﬂush with plenty of water for at least 10 minutes and seek medical advice if necessary.